編號 | 中文名稱 日本語標題 | 英文名稱 |
---|---|---|
JIS A1436-1991 | 充分粘結在基質上的涂層和片層的脫落能力的試驗方法 建築用被膜狀材料の下地不連続部における耐疲労性試験方法 | Test methods for movement capability of coatings and sheets fully adhered on substrate |
JIS A1902-3-2006 | 建筑產品用揮發性有機化合物和醛的排放測定.取樣、試樣制備和試驗條件.第3部分:涂料和涂層材料 建築材料の揮発性有機化合物(VOC),ホルムアルデヒド及び他のカルボニル化合物放散量測定におけるサンプル採取,試験片作製及び試験條件―第3部:塗料及び建築用仕上塗材 | Determination of the emission of volatile organic compounds and aldehydes for building products -- Sampling, preparation of test specimens and testing condition -- Part 3: Paints and coating materials |
JIS A6021-2000 | 建筑物防水薄膜涂層用液態使用的化合物 建築用塗膜防水材 | Liquid-applied compounds for waterproofing membrane coating of buildings |
JIS A6021 AMD 1-2006 | 建筑物防水薄膜涂層用液態使用的化合物(修改件1) 建築用塗膜防水材(追補1) | Liquid-applied compounds for waterproofing membrane coating of buildings (Amendment 1) |
JIS A6111-2004 | 房屋用涂層板 透濕防水シート | House wrapping sheets |
JIS A6909-2003 | 建筑物紋理精整用涂層材料 建築用仕上塗材 | Coating materials for textured finishes of buildings |
JIS A6909 AMD 1-2006 | 建筑物紋理精整用涂層材料(修改件1) 建築用仕上塗材(追補1) | Coating materials for textured finishes of buildings (Amendment 1) |
JIS C8380-1993 | 電纜溝道用塑料涂層鋼管 ケーブル保護用合成樹脂被覆鋼管 | Plastic coated steel pipes for cable-ways |
JIS G3443-3-2007 | 供水用鍍層鋼管.第3部分:外部塑料涂層 水輸送用塗覆裝鋼管―第3部:外面プラスチック被覆 | Coated steel pipes for water service -- Part 3: External plastic coatings |
JIS G3443-4-2007 | 供水用鍍層鋼管.第4部分:內部環氧涂層 水輸送用塗覆裝鋼管―第4部:內面エポキシ樹脂塗裝 | Coated steel pipes for water service -- Part 4: Internal epoxy coatings |
JIS G3536 ERRATUM 1-2000 | 用于預應力混凝土用無涂層的消除應力鋼絲和絞合鋼繩(勘誤 1) | Uncoated stress-relieved steel wires and strands for prestressed concrete (Erratum 1) |
JIS G5528-1984 | 球墨鑄鐵管道和配件內壁環氧粉末涂層 ダクタイル鋳鉄管內面エポキシ樹脂粉體塗裝 | Epoxy-powder coating for interior of ductile iron pipes and fittings |
JIS H8402-2004 | 熱噴涂層張力粘度的試驗方法 溶射皮膜の引張密著強さ試験方法 | Test methods of tensile adhesive strength for thermal-sprayed coatings |
JIS H8602-1992 | 鋁及鋁合金的陽極氧化和有機涂層的復合覆層 アルミニウム及びアルミニウム合金の陽極酸化塗裝複合皮膜 | Combined coatings of anodic oxide and organic coatings on aluminium and aluminium alloys |
JIS H8602 AMD 1-2006 | 鋁及鋁合金的陽極氧化和有機涂層的復合覆層(修改件1) アルミニウム及びアルミニウム合金の陽極酸化塗裝複合皮膜(追補1) | Combined coatings of anodic oxide and organic coatings on aluminium and aluminium alloys (Amendment 1) |
JIS H8641-2007 | 熱浸鍍鋅涂層 溶融亜鉛めっき | Hot dip galvanized coatings |
JIS H8667-2002 | 金屬陶瓷噴鍍涂層的試驗方法 サーメット溶射皮膜試験方法(廃止) | Test methods for cermet sprayed coatings |
JIS H8680-1-1998 | 鋁和鋁合金陽極氧化涂層厚度的試驗方法.第1部分:顯微鏡法 アルミニウム及びアルミニウム合金の陽極酸化皮膜厚さ試験方法 ― 第1部:顕微鏡斷面測定法 | Test methods for thickness of anodic oxide coatings on aluminium and aluminium alloys -- Part 1: Microscopical method |
JIS H8685-1-1999 | 鋁及鋁合金的著色陽極氧化涂層耐光牢度的加速試驗方法.第1部分:耐人工光照色牢度試驗 アルミニウム及びアルミニウム合金の著色陽極酸化皮膜の促進耐光性試験方法 ― 第1部:光堅ろう度試験 | Accelerated test methods for light fastness of coloured anodic oxide coatings on aluminium and aluminium alloys -- Part 1: Test for light fastness to artificial light |
JIS H8686-2-1999 | 鋁和鋁合金陽極氧化涂層顯像清晰度試驗方法.第2部分:儀表法 アルミニウム及びアルミニウム合金の陽極酸化皮膜の寫像性試験方法 ― 第2部:機器測定法 | Test methods for image clarity of anodic oxide coatings on aluminium and aluminium alloys -- Part 2: Instrumental method |
JIS H9303-2004 | 金屬陶瓷噴鍍涂層的推薦規程 サーメット溶射作業標準(廃止) | Recommended practice for cermet sprayed coatings |
JIS K3151-1996 | 為確保涂料、清漆和相關涂層良好的粘著性采用磷酸鹽轉化涂層的推薦標準 塗裝下地用りん酸塩化成処理剤 | Recommendations for phosphate conversion coatings to ensure good adhesion of paints, varnishes and related coatings |
JIS K5500-2000 | 涂層材料術語匯編 塗料用語 | Glossary of terms for coating materials |
JIS K5600-5-4-1999 | 涂料的試驗方法.第5部分:涂層膜的機械特性.第4節:刮痕硬度(鉛筆方法) 塗料一般試験方法 ― 第5部:塗膜の機械的性質 ― 第4節:引っかき硬度(鉛筆法) | Testing methods for paints -- Part 5: Mechanical property of film -- Section 4: Scratch hardness (Pencil method) |
JIS K5600-8-1-1999 | 涂料試驗方法.第8部分:涂層老化評估.第1節:一般原則和額定值表 塗料一般試験方法 ― 第8部:塗膜劣化の評価 ― 第1節:一般的な原則と等級 | Testing methods for paints -- Part 8: Evaluation of degradation of paint coatings -- Section 1: General principles and rating schemes |
JIS K5600-8-2-2008 | 涂料試驗方法.第8部分:涂層老化評估.第2節:起泡程度標識 塗料一般試験方法―第8部:塗膜劣化の評価―第2節:膨れの等級 | Testing methods for paints -- Part 8: Evaluation of degradation of paint coatings -- Section 2: Designation of degree of blistering |
JIS K5600-8-4-1999 | 涂料試驗方法.第8部分:涂層老化評估.第4節:開裂程度標識 塗料一般試験方法 ― 第8部:塗膜劣化の評価 ― 第4節:割れの等級 | Testing methods for paints -- Part 8: Evaluation of degradation of paint coatings -- Section 4: Designation of degree of cracking |
JIS K5970-2003 | 室內地板涂層 建物用床塗料 | Interior floor coating |
JIS K6404-2-2-1999 | 橡膠或塑料涂層織物的測試方法.整卷特性測定.第2部分:單位面積總質量、單位面積涂層量和襯底單位面積質量的 ゴム引布?プラスチック引布試験方法 ― 第2部:ロールの特性値の測定方法 ― 第2節:引布の単位面積當たりの総質量並びにコーティング材及び基布の単位面積當たりの質量の測定 | Testing methods for rubber-or plastics-coated fabrics -- Determination of roll characteristics -- Part 2: Methods for determination of the total mass per unit area, coating mass per unit area, and mass per unit area of the substrate |
JIS K6404-2-3-1999 | 橡膠或塑料涂層織物的測試方法.整卷特性測定.第3部分:厚度的測定方法 ゴム引布?プラスチック引布試験方法 ― 第2部:ロールの特性値の測定方法 ― 第3節:厚さの測定 | Testing methods for rubber-or plastics-coated fabrics -- Determination of roll characteristics -- Part 3: Method for determination of thickness |
JIS K6744-1992 AMENDMENT:2007 | 聚氯乙烯涂層和層壓金屬板 ポリ塩化ビニル被覆金屬板 | Polyvinyl chloride coated and laminated metal sheets |
JIS K6744-1992 | ポリ塩化ビニル被覆金屬板(追補1) | Polyvinyl chloride coated and laminated metal sheets (Amendment 1) |
JIS K6772-1994 | 聚氯乙烯涂層織物 ビニルレザークロス | Polyvinylchloride coated fabric |
JIS K6894-1996 | 金屬基片的氟塑料涂層膜 金屬素地上のふっ素樹脂塗膜 | Fluoroplastic coating film on metal substrate |
JIS M8016-1991 | 紙張?zhí)盍虾屯繉拥脑囼灧椒?br>製紙用ろう石クレーの試験方法 | Testing methods of filler and coating clay for paper |
JIS Z1514-1994 | 聚乙烯涂層紙 ポリエチレン加工紙 | Polyethylene coated paper |
JIS Z1528-2004 | 雙面涂層的壓敏膠帶 両面粘著テープ | Pressure sensitive adhesive double coated tapes |
JIS Z1541-2004 | 高位差壓敏雙面涂層膠粘帶 超強力両面粘著テープ | High potential pressure sensitive adhesive double coated tapes |
JIS Z1708-1976 | 可噴涂、可剝塑料防護涂層 塗裝形可はく性プラスチック | Sprayable and strippable protective plastic coatings |
編號 | 中文名稱 日本語標題 | 英文名稱 |