| 編號 | 中文名稱 | 英文名稱 |
|---|
| BS 5060-1987
| 回風電扇及調節器的性能和結構規范
| Specification for performance and construction of electric circulating fans and regulators
|
| BS 5285-1975
| 非工業用交流電風扇及調節器性能規范
| Specification - Performance of a.c. electric ventilating fans and regulators for non-industrial use
|
| BS 6448-1995
| DN大于50的燃氣調節器和進氣口壓力可達200mbar規范
| Specification for gas appliance governors of DN greater than 50 and for inlet pressures up to 200 mbar
|
| BS 6493-1.3-1986
| 半導體器件.分立器件.信號(包括開關)和調節器二極管推薦標準
| Semiconductor devices - Discrete devices - Recommendations for signal (including switching) and regulator diodes
|
| BS 7461-1991
| 裝有流量調節器、閉路開關檢驗、閉合位置指示開關或氣流量控制器電動式氣體自動關閉閥規范
| Specification for electrically operated automatic gas shut-off valves fitted with throughput adjusters, proof of closure switches, closed position indicator switches or gas flow control
|
| BS AU 232-1989
| 裝有調節器的道路車輛交流發電機的試驗和一般要求方法
| Methods of test and general requirements for road vehicle alternators with regulators
|
| BS DD CEN/TS 14825-2004
| 對流式供暖和制冷用帶有電動壓縮機的空氣調節器、液體制冷包和熱泵.部分負載條件下的檢驗和額定
| Air conditioners, liquid chilling packages and heat pumps with electrically driven compressors for space heating and cooling - Testing and rating at part load conditions
|
| BS DD ENV 50231-1997
| 航空用地面照明電氣設施.恒定電流調節器.設備規范和試驗
| Aeronautical ground lighting electrical installation - Constant current regulator - Equipment specifications and tests
|
| BS EN 12067-1-1999
| 燃氣噴嘴和燃氣裝置用燃氣/空氣混合調節器.第1部分:氣動結構類型
| Gas/air ratio controls for gas burners and gas burning appliances - Pneumatic types
|
| BS EN 12078-1998
| 燃氣爐和燃氣器具的零調節器
| Zero governors for gas burners and gas burning appliances
|
| BS EN 125400-1984
| 電子元件質量評定協調體系.分規范.電感器和調諧變壓器與磁性氧化鐵芯一起使用的調節器
| Harmonized system of quality assessment for electronic components: sectional specification: adjusters used with magnetic oxide cores for use in inductors and tuned transformers
|
| BS EN 12864-2001
| 用于丁烷、丙烷或其混合物的容量小于或等于4kg/h、最大出口壓力小于或等于200mbar的不可調低的調節器及其相
| Low-pressure, non adjustable regulators having a maximum outlet pressure of less than or equal to 200 mbar, with a capacity of less than or equal to 4 kg/h, and their associated safety devices for butane, propane or their mixtures |
| BS EN 13785-2005
| 丁烷、丙烷或其混合物用容量100 kg/h及以下和最大輸出壓力4巴及以下的調節器.不包括EN 12864中設備及其相關
| Regulators with a capacity of up to and including 100 kg/h, having a maximum nominal outlet pressure of up to and including 4 bar, other than those covered by EN 12864 and their associated safety devices for butane, propane or their mixtures
|
| BS EN 13787-2001
| 入口壓力達100巴的氣體壓力調節器及相關安全裝置的彈性體.
| Elastomers for gas pressure regulators and associated safety devices for inlet pressures up to 100 bar
|
| BS EN 13918-2003
| 氣焊設備.焊接、切割和相關工藝用儲氣瓶上的組合流量計調節器.分類、規范和試驗
| Gas welding equipment - Integrated flowmeter regulators used on cylinders for welding, cutting and allied processes - Classification, specification and tests
|
| BS EN 246-2003
| 衛生設備用水龍頭.流速調節器通用規范
| Sanitary tapware - General specifications for flow rate regulators
|
| BS EN 334-1999
| 入口壓力不大于100bar的氣體壓力調節器
| Gas pressure regulators for inlet pressures up to 100 bar
|
| BS EN 334-2005
| 進氣口壓力不大于100bar的氣壓調節器
| Gas pressure regulators for inlet pressures up to 100 bar
|
| BS EN 60335-2-40-2003
| 家用和類似用途電器的安全規范.特殊要求.電熱泵、空氣調節器和去濕器
| Household and similar electrical appliances - Safety - Particular requirements for electrical heat pumps, air-conditioners and dehumidifiers
|
| BS EN 60730-2-11-1994
| 家用和類似用途自動電控裝置規范.專門要求.能量調節器
| Specification for automatic electrical controls for household and similar use - Particular requirements - Energy regulators
|
| BS EN 61136-1-1998
| 半導體電源變換器.調速電驅動系統.一般要求.直流電動機驅動額定值規范
| Semiconductor power convertors - Adjustable speed electric drive systems - General requirements - Rating specifications, particularly for d.c. motor drives
|
| BS EN 61683-2000
| 光電系統.電功率調節器.效能測量程序
| Photovoltaic systems - Power conditioners - Procedure for measuring efficiency
|
| BS EN 61800-1-1998
| 可調速的電驅動系統.低電壓可調速直流電驅動系統額定規范
| Adjustable speed electrical power drive systems - Rating specifications for low voltage adjustable speed d.c. power drive systems
|
| BS EN 61800-2-1998
| 調速電驅動系統.一般要求.低壓調頻交流電驅動系統額定值規范
| Adjustable speed electrical power drive systems - General requirements - Rating specifications for low voltage adjustable frequency a.c. power drive systems
|
| BS EN 61800-3-2005
| 可調速的電驅動系統.電磁兼容性要求和特定試驗方法
| Adjustable speed electrical power drive systems - EMC requirements and specific test methods
|
| BS EN 61800-4-2003
| 可調速的電力驅動系統.一般要求.大于1000V但不超過35KV交流電驅動系統的額定值規范
| Adjustable speed electrical power drive systems - General requirements - Rating specifications for a.c. power drive systems above 1 000 V a.c. and not exceeding 35 kV
|
| BS EN 61800-5-1-2003
| 可調速的電驅動系統.安全要求.電、熱及能量
| Adjustable speed electrical power drive systems - Safety requirements - Electrical, thermal and energy
|
| BS EN 61822-2003
| 機場照明和信標導航用電氣裝置.恒流調節器
| Electrical installations for lighting and beaconing of aerodromes - Constant current regulators
|
| BS EN 738-2-1999
| 醫用氣體用的壓力調節器.供氣支管壓力調節器和輸氣管道壓力調節器
| Pressure regulators for use with medical gases - Manifold and line pressure regulators
|
| BS EN 738-3-1999
| 醫療用氣體的壓力調節器.與氣瓶閥組合的壓力調節器
| Pressure regulators for use with medical gases - Pressure regulators integrated with cylinder valves
|
| BS EN 738-4-1999
| 醫療用氣體的壓力調節器.醫療設備用低壓力調節器
| Pressure regulators for use with medical gases - Low-pressure regulators intended for incorporation into medical equipment
|
| BS EN 88-1991
| 入口壓力達200毫巴的燃氣器具的壓力調節器
| Pressure governors for gas appliances for inlet pressures up to 200 mbar
|
| BS EN ISO 7291-2001
| 氣焊設備.300bar以下的焊接、切削及相關工藝用匯流系統用壓力調節器
| Gas welding equipment - Pressure regulators for manifold systems used in welding, cutting and allied processes up to 300 bar
|
| BS ISO 10294-1-1997
| 耐火試驗.空氣分配系統用火焰調節器.第1部分:試驗方法
| Fire-resistance tests - Fire dampers for air distribution systems - Test method
|
| BS ISO 10294-3-1999
| 耐火試驗.空氣分配系統用火焰調節器.試驗方法指南
| Fire-resistance tests - Fire dampers for air distribution systems - Guidance on the test method
|
| BS ISO 13555-1-2003
| 柴油發動機.柴油噴注設備動態調速的檢查程序.預調節
| Diesel engines - Procedure for checking the dynamic timing of diesel fuel injection equipment - Preconditioning
|
| BS ISO 14617-8-2004
| 圖示的圖形符號.閥門和氣流調節器
| Graphical symbols for diagrams - Valves and dampers
|
| DD ENV 50231-1997
| 航空用地面照明電氣設備.恒定電流調節器的設備規范和試驗
| Aeronautical ground lighting electrical installation. Constant current regulator. Equipment specifications and tests
|
| 編號 | 中文名稱 | 英文名稱 |
|---|